Mounting On Rotary Actuator - ABB TZIDC-200 Operating Instruction

TZIDC-200 DIGITAL POSITIONER | OI/TZIDC-200-EN REV. C

Mounting on rotary actuator

For mounting on part-turn actuators in accordance with
VDI / VDE 3845, the following attachment kit is available:
Figure 11: Components of attachment kit
• Adapter with spring
1
• four M6 screws each
4
to fasten the attachment bracket
• four M5 screws , Spring washers
7
fasten the attachment bracket to the actuator
Required tools:
• Wrench, size 8 / 10
• Allen key, size 3
5
, spring washers and washers
3
to the positioner
6
and washers
8
Figure 12: Mounting the adapter on the positioner
1. Determine the mounting position
(parallel to actuator or at 90° angle)
2. Calculate the rotational direction of the actuator
(right or left).
3. Move the part-turn actuator into the home position.
4. Pre-adjust feedback shaft.
 To ensure the positioner will operate within the operating
range (see chapter General on page 15), the mounting
2
position as well as the home position and direction of
rotation of the actuator must be taken into account when
to
9
determining the adapter position on the feedback shaft
For this purpose, the feedback shaft can be adjusted
manually so that the adapter
correct position.
5. Place the adapter in the proper position on the feedback
shaft and fasten with threaded pins
pins must be locked in place on the flat side of the feedback
shaft.
can be attached in the
3
. One of the threaded
2
19
.
1