Advertisement
INSTALLATION INSTRUCTIONS
Attach Drip Trays and Handles (cont.)
7
Locate the dispensing levers, packaged inside the
bowls. Install them on the tap handles. While pulling
outward on both sides of the base of the dispensing
lever, insert the pins on the bottom of the handle into
the base holes on the lever.
8
Lubricate the tap mounting slots using food grade
lubricant.
9
Prepare the tap handle assembly for attachment.
Lubricate the red rubber seal on the back of the tap
handle assembly with food grade lubricant (1 tube
included). Insert the seal into the tap hole on the
bottom of the bowl. Line up the spring and the middle
pins on the handle, as shown. NOTE: Later versions of
the mixing bowl have a hook to help line up the spring.
10 Attach the tap handle assembly. Push in with your
thumb on the center of the handle until the tap handle
assembly pops into place.
continued....
Base
Lever
Spring must be
between mounts
Lubricate tap
seal (red)
DO NOT
push here
Push
here
II42
Handle
7
Mount
(lubricate)
Line up as
shown
8
9
10
040419A
Advertisement
