Table of Contents
Advertisement
Configuring the device
The i-5 Series can be set up by using the control panel and OLED multi-line display at the base of the fixture or through RDM.
Please note: In POI versions there is no display mounted in the fixture. The adjustments are made through RDM.
See page 19 for more information.
The OLED display is the human interface of the fixture as it displays the current status and menu of the fixture. The display panel
can be used to configure individual fixture settings, check the fixture's wireless status, confirm the firmware version, and read error
messages. The complete list of the menu and all commands available are listed in "Control Menu" on page 15-16.
Before turning on the i-5, make sure the power cable is properly connected. After powering the fixture, the display shows the currently
selected operating mode, the DMX start address and other information.
Navigate through the menus and options using the arrow buttons, and select items using the ENTER button.
Using the display panel
•
Press the 'ENTER' button to access the menu or make a selection.
•
Press the arrow buttons to scroll up and down in the menus.
•
Press the 'ESC' button to take a step back in the menu.
•
UP + DOWN arrows simultaneously = flip the display upside-down.
Display
A - Operational mode
B - DMX address
C - External data indicator
D - External data protocol
Operational mode (A)
Displays the current mode (quick color, stand-alone, or DMX mode). The fixture is set by default to be controlled in DMX mode.
DMX Address (B)
Displays the current DMX address. The DMX address is altered directly from this view.
External data indicator (C)
The DMX signal indicator will flash when the DMX control is active.
External data protocol (D)
Shows the current input type / external data protocol (CRMX™ or DMX).
•
When 'DMX' is displayed: the fixture responds to data received through cabled DMX.
•
When 'CRMX' is displayed: the fixture responds to data received through wireless DMX.
The next available DMX address will show below, depending on the fixture's DMX footprint.
Error Indicator
If any errors are detected, the message 'ERR' will be flashing in the display for easy detection.
To read the error message, select ENTER → INFO → ERRORS in the menu.
101
DMX
6CH CTC MODE
(107)
Figure 8: i-5 OLED display and control panel
A
6CH CTC MODE
Figure 10: OLED display
ESC
ENTER
B
C D
101
DMX
(107)
ESC
Figure 9: Control panel
9
Advertisement
Table of Contents
