Table of Contents
Advertisement
POI Spanner
The i-5 POI includes a spanner with two types of pig-nose keys used for tilt
adjustment in POI fixtures. Depending on the type of fixture, either use the large
or the small pig-nose keys.
In i-5 POI Series the largest pig-nose key is used for tilt adjustment.
POI Tilt lock
The tilt angle in POI fixtures may be adjusted by using the large pig-nose key provided in the spanner.
To adjust the tilt angle in i-5 POI take the following steps:
1. Make sure the fixture is cooled down before handling.
2. Take the spanner and turn both tilt lock screws (one on each side) counter-clockwise by using
the large pig-nose key. Screws are loosened by turning counter-clockwise.
3. Tilt the fixture to the angle desired and hold it.
4. Lock the position by tightening the tilt lock screws clockwise with the same pig-nose key.
Installation and rigging the i-5 POI
While the base of the standard products include 1/4 turn fasteners camlocks for omega brackets, the base of POI products come
with M-10 nuts for M-10 screws. The M-10 screws are included in the package in the same amount as the number of M-10 nuts of
the base.
The i-5 POI has four M-10 nuts in the base that can be used for installation and rigging. The SGM Omega bracket (not included) or
a customized bracket is needed to install the fixture. Consider the dimensions below of the i-5 POI base for customized mounting
brackets purposes.
The SGM POI Omega bracket suited for M-10 holes can be ordered as an accessory. Contact your local SGM dealer for further
information on correct POI rated mounting.
Connecting DMX and AC power in POI
DMX in and DMX out are in the same cable. See more in figure 19 about the SGM POI DMX cable.
The power is wired as the standard version. See "Connecting AC power" on page 8.
For permanent installations, have a qualified electrician wire the mains cable directly to a suitable branch circuit. The junction's
ingress protection (IP) rating must be suitable for the location.
For a temporary installation, the mains cable may be fitted with a grounded connector intended for exterior use.
PLEASE NOTE!!
•
Standard microphone cable are not suitable for transmitting DMX.
•
Up to 32 fixtures can be on the same DMX link. Additional fixtures will overload the link.
•
The last fixture must always be fitted with a DMX termination plug to the fixtures DMX out.
•
SGM fixtures provide a passive DMX Thru signal as DMX Out, instead of an active output signal.
20
Figure
19: i-5 POI base with dimensions
B
A
C
Figure 17: POI Spanner
Figure 18: i-5 POI Tilt lock
A: Magnet
B: Small pig-nose key
C: Large pig-nose key
Advertisement
Table of Contents
