Using The Front Control Buttons And Lcd - Fortinet FortiGate FortiGate-300 Installation Manual

Using the front control buttons and LCD

Using the front control buttons and LCD
28
2 If the Static Route table contains a default route (IP and Mask set to 0.0.0.0), select
the Delete icon to delete this route.
3 Select Create New.
4 Set Destination IP to 0.0.0.0.
5 Set Mask to 0.0.0.0.
6 Set Gateway to the default gateway IP address.
7 Set Device to the interface connected to the external network.
8 Select OK.
Basic settings, including interface IP addresses,
netmasks, default gateways, and the FortiGate
operating mode can be configured using the LCD
and front control buttons on the FortiGate unit. Use
the information that you recorded in
page 26 to complete the following procedure. Start when Main Menu is displayed on
the LCD.
Note: You cannot configure DHCP or PPPoE from the control buttons and LCD. Instead you
can use the web-based manager, the CLI, or the setup wizard.
To change the IP address and netmask of an interface
1 Press Enter to display the interface list.
2 Use the up and down arrows to highlight the name of the interface to change and
press Enter.
3 Press Enter for IP address.
4 Use the up and down arrow keys to increase or decrease the value of each IP address
digit. Press Enter to move to the next digit. Press Esc to move to the previous digit.
Note: When you enter an IP address, the LCD always shows three digits for each part of the
address. For example, the IP address 192.168.100.1 appears on the LCD as 192.168.100.001.
The IP address 192.168.23.45 appears as 192.168.023.045.
5 After you set the last digit of the IP address, press Enter.
6 Use the down arrow to highlight Netmask.
7 Press Enter and change the Netmask.
8 After you set the last digit of the Netmask, press Enter.
9 Press Esc to return to the Main Menu.
Table 5 on
01-28004-0021-20040830
NAT/Route mode installation
Fortinet Inc.