Lcd Front Control Buttons - Fortinet FortiGate FortiGate-200A Install Manual

LCD front control buttons

LCD front control buttons
24
6 Type admin and press Enter twice.
The following prompt is displayed.
Welcome!
Type ? to list available commands. For information about how to use the CLI, see
the FortiGate CLI Reference.
You can use the front control buttons and LCD to configure the basic settings on
your FortiGate unit. This configuration method provides an easy and fast method
to configure your FortiGate unit. You can configure:
• IP addresses
• netmasks
• default gateways
• operating modes
• restore factory default settings
The LCD provides information on the FortiGate unit's operating modes and
whether or not it is part of a High Availability (HA) cluster.
default LCD main menu setting of a FortiGate unit, operating in NAT/Route mode
and not connected to a HA cluster.
Figure 6: Default LCD main menu settings
Menu [ Fortigat -> ]
NAT, Standalone
Table 6: LCD main menu definitions
Menu
[Fortigat ->]
NAT
Standalone
The front control buttons control how you enter and exit the different menus when
configuring the different ports and interfaces. The front control buttons also
enables you to increase or decrease each number for configuring IP addresses,
default gateway addresses, or netmasks. The following table defines each button
and what it does when configuring the basic settings of your FortiGate unit.
Table 7: Front control button definitions
Enter Enables you to move forward through the configuration process.
Esc Enables you to move backward, or exit out of the menu you are in.
FortiGate-200A, FortiGate-300A, FortiGate-400A, and FortiGate-500A FortiOS 3.0 MR4 Install Guide
The menu the LCD currently displays.
The FortiGate unit's host name.
The current operational mode of the FortiGate unit.
The FortiGate unit is not part of a HA cluster. For more information
on standalone mode and HA, see the
Guide.
Installing the FortiGate unit
Figure 6 shows the
FortiGate Administration
01-30004-0268-20070712