Powering Off The Fortigate Unit - Fortinet FortiGate FortiGate-200A Install Manual

Powering on the FortiGate unit

Powering off the FortiGate unit

20
After a few seconds, SYSTEM STARTING appears on the LCD.
The main menu setting appears on the LCD when the system is running.
Menu [ Fortigat -> ]
NAT, Standalone
The FortiGate unit starts and the Power LEDs light up.
Table 5: Led indicators
LED State
Power Green
Off
Status Flashing
Green
Green
Off
Internal Amber
External
WAN1
Flashing
WAN2 Amber
DMZ1
Green
DMZ2
LAN (L1 -L4)
Red
1, 2, 3, 4, 5, 6
Off
Always shut down the FortiGate operating system properly before turning off the
power switch to avoid potential hardware problems.
To power off the FortiGate unit
1 From the web-based manager, go to System > Status.
2 In the Unit Operation display, select Shutdown, or from the CLI, enter:
execute shutdown
3 Turn off the power switch.
4 Disconnect the power supply.
FortiGate-200A, FortiGate-300A, FortiGate-400A, and FortiGate-500A FortiOS 3.0 MR4 Install Guide
Description
The FortiGate unit is powered on.
The FortiGate unit is powered off.
The FortiGate unit is starting up.
The FortiGate unit is running normally.
The FortiGate unit is powered off.
The correct cable is in use, and the connected equipment has
power.
Network activity at this interface.
The interface is connected.
• 1, 2, 3, 4, 5 and 6 connect at up to 100 Mbps
Ports 5 and 6 connect at up to 1000 Mbps.
No link established.
Installing the FortiGate unit
01-30004-0268-20070712