Table of Contents
Advertisement
Installation
Attaching the Stand (Type one) (C43J890DK* / C43J892DK*)
― Before assembling the product, place the product down on a flat and stable surface so that the screen is facing downwards.
: The product is curved. Placing pressure on the product when on a flat surface may damage the product. When the product is on the ground facing up or down, do not put pressure on it.
― There is a risk of scratch damage if the screwdriver comes in contact with the product surface while fastening the screws. Make sure the screwdriver does not touch the surface.
Caution
Remove the Cushion Top and Cushion Front,
and then place the Cushion Front on the desk.
Hold the stand neck with both
hands, not one hand, to prevent it
from falling off and causing injury.
1 4
Fasten the screws at the top of the
Insert the stand base into the stand neck in
stand neck.
the direction as shown in the figure.
1 1
1 5
1 2
1 3
Pull the monitor out of the
Place the stand neck on the
package (two people are required
monitor as shown in the figure.
for this work), and then place the
monitor on the Cushion Front.
1 6
1 7
Assemble the COVER-CLEAN BACK
Push the COVER-CLEAN BACK
STAND to the stand neck as shown
STAND in the direction as shown in
in the figure.
the figure.
Caution
Tilt the stand neck to sides to avoid contact
with the screwdriver.
19
Advertisement
Table of Contents
