Using The Front Control Buttons And Lcd - Fortinet FortiGate FortiGate-1000 Install Manual

NAT/Route mode installation

Using the front control buttons and LCD

FortiGate-200, FortiGate-300, FortiGate-400, FortiGate-500 and FortiGate-1000 FortiOS 3.0 MR4 Install Guide
38
Basic settings, including interface IP addresses, netmasks, default gateways, and
the FortiGate operating mode can be configured using the front control buttons
and LCD. Use the information you recorded in
the following procedure. Start when the main menu setting is displayed on the
LCD.
Note: The FortiGate-200 does not have front control buttons and LCD. If you have a
FortiGate-200, go to "Using the web-based manager" on page 43
line interface" on page 39.
Note: You cannot configure DHCP or PPPoE from the front control buttons and LCD.
Instead, you can use the web-based manager or the CLI.
To change the IP address and netmask of an interface
1 Press Enter to display the interface list.
2 Use the up and down arrows to highlight the name of the interface to change and
press Enter.
3 Press Enter for IP address.
4 Use the up and down arrow keys to increase or decrease the value of each IP
address digit. Press Enter to move to the next digit. Press Esc to move to the
previous digit.
5 After you set the last digit of the IP address, press Enter.
6 Use the down arrow to highlight Netmask.
7 Press Enter and change the Netmask.
8 After you set the last digit of the Netmask, press Enter.
9 Press Esc to return to the main menu setting.
Note: When you enter an IP address, the LCD always shows the three digits for each part
of the address. For example, the IP address 192.168.100.1 appears on the LCD as
192.168.100.001. The IP address 192.168.23.45 appears as 192.168.023.045.
To add a default gateway to an interface
1 Press Enter to display the interface list.
2 Use the down arrow key to highlight the name of the interface connected to the
Internet and press Enter.
3 Use the down arrow to highlight Default Gateway.
4 Press Enter and set the default gateway.
5 After you set the last digit of the default gateway, press Enter.
6 Press Esc to return to the main menu setting.
You will have to configure the DNS server settings through either the web-based
manager or the CLI. There is no option on the LCD to configure DNS server
settings.
Configuring the FortiGate unit
Table 14 on page 35 to complete
or "Using the command
01-30004-0267-20070215