Powering Off The Fortigate Unit - Fortinet FortiGate FortiGate-1000 Install Manual

Installing the FortiGate unit

Powering off the FortiGate unit

1
2
3
4
FortiGate-200, FortiGate-300, FortiGate-400, FortiGate-500 and FortiGate-1000 FortiOS 3.0 MR4 Install Guide
01-30004-0267-20070215
After a few seconds, SYSTEM STARTING appears on the LCD.
The main menu setting appears on the LCD when the system is running.
.
Menu [ Fortigat -> ]
NAT, Standalone
The FortiGate unit starts and the Power and Status LEDs light up. The Status LED
flashes while the FortiGate unit starts up, and remains off when the system is
running.
Table 6: LED indicators
LED State
Power Green
Off
Status Flashing
Green
Off
Internal Green or
Amber
External
DMZ
Flashing
HA Green or
Flashing
1 to 8
Amber
Green
Red
Off
Note: The FortiGate-200 and the FortiGate-300 both have green LED indicators, indicating
the links on those units. The FortiGate-400, FortiGate-500 and the FortiGate-1000 have
amber LED indicators that indicate the links on those units.
Note: The FortiGate-200 does not have front control buttons and LCD. If you have a
FortiGate-200, disregard all information concerning the front control buttons and LCD.
Always shut down the FortiGate operating system properly before turning off the
power switch to avoid potential hardware problems.
To power off the FortiGate unit
From the web-based manager, go to System > Status.
In the Unit Operation display, select Shutdown, or from the CLI enter:
execute shutdown
Turn off the power switch.
Disconnect the power cable from the power supply.
Description
The FortiGate unit is powered on.
The FortiGate unit is powered off.
The FortiGate unit is starting up.
The FortiGate unit is powered on.
The correct cable is in use, and the connected equipment
has power.
Network activity at this interface.
The interface is connected at 100 Mbps.
The interfaces 5 and 6 are connected at 1000 Mbps.
No link is established.
Powering on the FortiGate unit
21