Flue Fitting Instructions - andrews RSC 9/145 Service Manual

3.4

Flue Fitting Instructions

Fig. 3
D4
D8
D5
D9
D2
D6
D1
Issue 4 21042018
D10
D3
D6
D7
1. Fit heater adaptor D1 to heater ensuring correct location on
primary flue spigot from heater. (Use 4 self tapping screws
provided).
2. Fit flue restrictor ring D7 into heater adaptor D1. The
correct size of restrictor for each heater model and
installation is shown on page 11.
3. Fit flue section D2 into heater adaptor D1.
4. Fit elbow D4 into flue section D2 for horizontal flue runs.
5. Determine correct position of flue outlet and fit outer wall
plate and inner wall plate. Fit flue outlet guard if required.
(Fixings not supplied).
6. Fit horizontal terminal D3 or make up lengths of flue required
(see page 11) into elbow D4. Each joint must be secured
with a sealed clamp D6.
7. For vertical installations fit flue lengths required (see page
11) into heater adaptor D1.
8. Determine correct position of flue terminal and fit either D8 or
D9 roof plates.
9. Fit D5 vertical terminal through roof plate into vertical flue
pipe.
10. Fit D6 sealed clamps on all joints.
11. On all installations the lengths of flue pipes may be cut to
obtain correct length of flue route required.
12