Duratrax Nitro Evader ST DTXD62 Quick Start

IMPORTANT: Read the instructions and watch the video for further details
RTR ASSEMBLY
Note: For more detailed instructions, refer to page 4 of
the assembly and operation manual.
2.
Install (8) "AA" batteries into
the transmitter. Check to make
sure the red power light glows
when the transmitter is on.
4.
Install (4) "AA" batteries into the
receiver battery holder.
5.
Decal and install the body.
®
on running and maintaining your new DuraTrax
1.
Install the transmitter
antenna into the transmitter.
3.
Install the receiver
antenna tube. Secure the
excess wire to the tube
using tape. DO NOT CUT
THE ANTENNA WIRE.
®
RUNNING THE NITRO EVADER
1.
Install the included "C"
size battery into the included
glow starter.
2.
Add fuel to the fuel tank using the included fuel bottle.
3.
Turn the transmitter "on" and check that the battery
indicator light is on. If the battery indicator light is not "on"
or is blinking, you need to change your transmitter
batteries before running your Nitro Evader.
4.
Turn on the Nitro Evader.
Squeeze for
forward
5.
Make sure the throttle opens all the way when the
throttle is applied on the transmitter. Make sure the brakes
work adequately when the trigger is pushed forward.
ADJUSTABLE
STEERING
RATE
6.
Make sure the front wheels of the Nitro Evader move left
and right correctly when the transmitter wheel is turned.
™
vehicle.
Push for
brake
THROTTLE
STEERING
TRIM
TRIM
™