Preparing The Remote Control Unit; Installing The Batteries; Remote Control Operation Range - Sharp PN-B401 Operation Manual

Preparing the Remote Control Unit

Installing the batteries

1. Place your finger on the part marked with the ▲, and then pull the cover off.
2. See the instructions in the compartment and put in the supplied batteries (R03 ("AAA" size) x 2) with their plus (+)
and minus (-) sides oriented correctly.
3. Close the cover.
TIPS
• When the batteries become exhausted, replace them with new (commercially available) batteries.
• The supplied batteries may become exhausted quickly depending on how they are stored.
• If you will not be using the remote control for a long time, remove the batteries.
• Use manganese or alkaline batteries only.

Remote control operation range

Remote control sensor in
The remote control can be operated even when the remote control sensor is stored inside the monitor.
Point the remote control unit toward the remote control sensor on the bottom of the monitor (or the right side of the monitor if
using portrait orientation).
For the monitor in landscape orientation
9.8 feet (3m)
20º
10º
10º
Remote control
9.8 feet
sensor
(3m)
10º10º
For the monitor in portrait orientation
9.8 feet
(3m)
20º
10º
10º
9.8 feet
(3m)
10º
10º
Remote control
sensor
15
E