5. Affix the adhesive tape to secure the touchpad bracket
6. Install the:
a.
battery
b.
base cover
7. Follow the procedure in
Display assembly
Removing the display assembly
1. Follow the procedure in
2. Remove the:
a.
base cover
b.
battery
c.
hard drive
d.
Removing the WLAN card
3. Remove the eDP cable from its connector on the system board [1] and unroute the cable from the routing channel on the
system fan [2].
4. Unroute the eDP cable from the routing channel on the system [3].
5. Peel the tape securing the WLAN cables [4] and unroute the cables from the routing channel.
6. Then, open the palmrest assembly and flip over the computer on a flat surfaced table.
After working inside your
Before working inside your
on page 18
computer.
computer.
Disassembly and reassembly
39