Table of Contents
Advertisement
1
1
Open the door fully and hold the two door hinges.
2
Lift and turn the levers on the two hinges.
3
Close the oven door halfway to the first opening position. Then pull forward and remove the door from
its seat.
4
Put the door on a soft cloth on a stable surface.
2
B
Hold the door trim (B) on the top edge of the door
at the two sides and push inwards to release the
clip seal. Pull the door trim to the front to remove it.
Hold the door glass panels by their top edge and
carefully pull them out one by one. Start from the
top panel. Make sure the glass slides out of the
supports completely.
Clean the glass panels with water and soap. Dry
the glass panels carefully.
When the cleaning is completed, install the glass
panels and the oven door. Do the above steps in
the opposite sequence.
Make sure that you put the glass panels (A and B)
back in the correct sequence. The first panel (A)
has a decorative frame. The screen-printing zone
must face the inner side of the door. Make sure that
after the installation the surface of the glass panel
20
2
1
3
frame (A) on the screen-printing zones is not rough
when you touch it.
A
B
Make sure that you install the middle panel of glass
in the seats correctly.
4
A
B
Advertisement
Table of Contents
