Speakers - HP ProOne 400 Maintenance And Service Manual

Speakers

The speakers are located at the bottom of the computer. Two separate speakers are each secured by two Torx
screws.
To remove the speakers:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. Remove the system board shield (see
6. Remove the bottom panel and trim (see
7. Disconnect the speaker cable from the system board (1).
8. Remove two Torx screws (2) that secure each speaker to the computer.
9. Remove speaker cable from the clips and routing path built into the chassis (3), and then remove the
speakers from the computer.
10. Remove the speakers from the computer.
To install the speakers, reverse the removal procedures.
Preparing to disassemble the computer on page
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
System board (EMI) shield on page
Feet, bottom panel and trim on page
23).
20).
24).
32).
19).
53).
Speakers 55