System Board (Emi) Shield - HP ProOne 400 Maintenance And Service Manual

System board (EMI) shield

The system board shield covers the system board. A latch holds the shield in place. Four screws secure the
shield.
To remove the system board shield:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. Remove the four Torx screws, and then lift the electromagnetic interference (EMI) shield off the system
board.
To install the system board shield, reverse the removal procedures.
32 Chapter 4 Removal and Replacement Procedures
Preparing to disassemble the computer on page
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
23).
20).
24).
19).