Vesa Mounting Bracket - HP ProOne 400 Maintenance And Service Manual

VESA mounting bracket

The VESA mounting bracket is located under the stand.
To remove the VESA mounting bracket:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. Remove the system board shield (see
6. Remove the cables that are routing along the top and left side of the mounting bracket.
7. Remove the five Torx screws, and then remove the bracket from the computer.
To replace the VESA mounting bracket, reverse the removal procedures.
Preparing to disassemble the computer on page
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
System board (EMI) shield on page
23).
20).
24).
32).
19).
VESA mounting bracket 45