JVC XV-S40BK Service Manual page 8

XV-S40BK/XV-S42SL/XV-S45GD/XV-S30BK
<Loading assembly section>
Removing the clamper assembly
1. Remove the four screws A attaching the clamper
assembly.
2. Move the clamper in the direction of the arrow to
release the two joints a on both sides.
ATTENTION: When reattaching, fit the clamper to
the two joints a.
Removing the tray (See Fig.2 and 3)
Prior to performing the following procedure, remove
the clamper assembly.
1. Push b of the slide cam into the slot on the left side
of the loading base until it stops.
2. Draw out the tray toward the front.
ATTENTION: Before reattaching the tray, slide the
part c of the slide cam to the right as
shown in Fig.3.
1-8
Joint a
(See Fig.1)
A
A
Clamper base
Fig.1
Push Tray
b
Fig.2
Slide cam
Fig.3
Joint a
A
A
Part c