JVC XV-S40BK Service Manual page 12

XV-S40BK/XV-S42SL/XV-S45GD/XV-S30BK
<Traverse mechanism assembly section>
Removing the feed motor assembly
1. Unsolder the two soldering j on the spindle motor
board.
2. Remove the two screws F attaching the feed motor
assembly.
Removing the feed motor
Prior to performing the following procedure, remove
the feed motor assembly.
1. Remove the screw G attaching the thrust spring.
ATTENTION: When reattaching the thrust spring,
make sure that the thrust spring
presses the feed gear (M) and the feed
gear (E) reasonably.
2. Remove the feed gear (M).
3. Pull out the feed gear (E) and the lead screw.
4. Remove the two screws H attaching the feed motor.
ATTENTION: When reattaching, pass the two cables
extending from the feed motor through
the notch k of the feed holder as
shown in Fig.13.
1-12
(See Fig.13)
(See Fig.13 to 15)
Feed motor assembly
F
F
Notch k
Soldering j
Spindle motor board
Fig.13
Lead screw
Fig.14
Feed motor
Feed holder
Fig.15
Pickup
Spindle motor
Feed gear (M)
Thrust spring
G
Feed gear (E)
H