2】Notes For Usage Of Core Drill - HAKKEN SPO-14Ae-U Instruction Manual

【2】Notes for Usage of Core Drill
(In case of combination with CONSEC's original Drill Carriage Assy. and Pole Base.)
1. Check for the embedded conduit etc.
◎ In case that you contact to the electric wire or conduit in that there are electric current, you
may receive the electric shocks.
◎ Before drilling the wall or the floor, check for the embedded conduit etc adequately.
2. Be sure to wear the rubber gloves and the rubber shoes.
◎ Since this machine uses the water, be sure to wear the rubber gloves and the rubber shoes.
3. Do not use for the ceiling plane.
◎ Since the core drill is used the water, it is extremely dangerous to drill for the ceiling plane
due to flowing the water into the inside of motor.
4. Regarding the operation of high-place work, please follow the applicable laws and regulations .
◎ Secure the safe scaffold, and do not operate the machine 1.5m higher than the scaffold.
◎ In case that you work at high place, secure the enough scaffold space and secured scaffold.
◎ In case that you work at high place, keep any person away under your working area.
5. Be careful for the safety of the penetration side.
◎ When drilling for the penetration, cutting core bit might fall out or the cutting water might be
leaked. Therefore, please do the safeguard and the drain water handling in order not to
avoid to hit the human beings or objects. Then, please start operating.
6. Use the proper voltage which is indicated on the nameplate.
◎ In case that you apply for the voltage which is over the indicated voltage, it will cause the
accidents.
7. Fix the Pole Base properly.
◎ It is extremely important to fix the pole base securely. If it is not fixed securely, the core bit
might be damaged by rattling of core drill or jammed.
8. Use the Water Collector for sure.
◎ Use Water Collector pad for sure in order to avoid the water flowing into the inside of motor
by flying apart the water during operation.
◎ When using Water Collector, please install it adequately in order not to leak the water.
9. Do not contact to the rotating Core Bit and Main Shaft.
◎ Do not contact your hands and body to the rotating Core Bit and Main Shaft. It might be
caught in or injured.
not
10. Do block the air hole of motor, and do not put the materials into the air hole.
11. Turn the switch off immediately if any abnormality is found.
◎ When the Core Bit stops or you hear the strange noise during the operation, please turn
switch off immediately.
12. In case that you use Vacuum Pad for fixing the Pole Base, please do not use the
Automatic Feeding System.
◎ The Pole Base comes up, and it is extremely dangerous.
13. Asbestos is the harmful to human beings. In case that you drill containing such materials,
please follow the applicable laws and regulations, and take a measure for dust control.
14. Do not use the Core Bit which has a outshoot.
◎ If the rotating objects has a outshoot, it might be the risk for being caught in or injured.
15. Do not use the Core Bit which exceeds the maximum diameter of core drill.
 WARNING
－4－