Installing A 9.5 Mm Slim Optical Drive - HP EliteDesk 800 G3 SFF Maintenance And Service Manual

Installing a 9.5 mm slim optical drive

1. Prepare the computer for disassembly
2. Remove the access panel
3. If you are installing a slim optical drive in a bay covered by a bezel blank, remove the front bezel and
then remove the bezel blank. See
4. Align the small pin on the release latch with the small hole on the side of the drive and press the latch
firmly onto the drive.
5. Slide the optical drive through the front bezel all the way into the bay (1) so that the latch on the rear of
the drive locks into place (2).
34 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
(Preparation for disassembly on page
(Access panel on page 21).
Slim optical drive bezel blank on page 22
20).
for more information.