Wlan Module - HP EliteDesk 800 G3 SFF Maintenance And Service Manual

WLAN module

The WLAN module installs into a connector on the system board.
For a list of available WLAN modules, see
To remove the WLAN module:
1. Prepare the computer for disassembly
2. Remove the access panel
3. Rotate the hard drive cage to its upright position
4. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
The WLAN antenna cable labeled "2" connects to the WLAN module "Aux" terminal labeled "2".
5. Remove the Phillips PM2.0×3.0 screw (2) that secures the WLAN module to the computer. (The edge of
the module opposite the slot rises away from the computer.)
6. Remove the WLAN module (3) by pulling the module away from the slot at an angle.
NOTE:
Reverse this procedure to install the WLAN module.
46 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
(Access panel on page
The WLAN antenna cable labeled "1" connects to the WLAN module "Main" terminal labeled "1".
WLAN modules are designed with a notch to prevent incorrect insertion.
Boards, cards, and ports on page
(Preparation for disassembly on page
21).
(Hard drive cage on page
9.
20).
41).