Using The Touchpad Remote Control Unit - Sharp AQUOS XU Series LC-70XU830X Operation Manual

<< How to select the TV Mode
ENGLISH | FRANÇAIS | PORTUGUÊS | РУССКИЙ | 中文 | INDONESIA | ภาษาไทย | TIẾNG VIỆT | ‫ | ﻋرﺑﻲ‬АҒЫЛШЫН | O'ZBEK TILIDA
Using the Touchpad Remote Control Unit
Preparation
Before using the Touchpad Remote Control Unit, you have to follow the procedure shown below to pair
the unit with the TV.
1 Select
(HOME) > "Settings" > "Remote & accessories" > "Add accessory".
2 Press the
(HOME) and
time for 5 seconds.
About 20 seconds later, "SHARP Remote control device" is shown on TV screen.
3 Select "SHARP Remote control device" on TV screen, and then press (ENTER) on the IR
Remote Control.
About 5-10 seconds later, PAIRED is shown. Preparation is complete.
NOTE
In preparation 3, if COULDN'T PAIR is shown, please try "preparation 1-3" again.
Pairing success/failure may be influenced by the surrounding wireless/RF environment.
Mouse/Flick mode switch button
Switch the touchpad between Mouse mode and Flick mode.
NOTE
The default is Flick mode.
Some apps may not function in Mouse mode. If an app does not function, switch to Flick mode.
Slide bar
You can slide to display the Devices screen.
EN 2-2
(Back) buttons on the Touchpad Remote Control Unit at the same
Slide from the left edge to the center to display the Devices
peek screen.
Slide from the left edge to the right edge to display the
Devices full screen.
>>