Specifications; Performance Data - GE PNRQ20RBL Owner's Manual & Installation Instructions

Specifications

Use Replacement Cartridge(s): FQROPF (pre and post filter)
and FQROMF (membrane filter)
The concentration of the indicated substances in water entering the
system was reduced to a concentration less than or equal to the
permissible limit for water leaving the system as specified in NSF/
ANSI Standard 42, Standard 58 and CSA B483.1.
Capacity 11.15 gpd (gallons per day) 42.2 lpd (liters per day).
Average
Substance Reduction
Influent
Chlorine Taste and Odor 2.0 mg/L
Nominal Particulate 70,333 pts/
mL
Arsenic (pentavlent) 0.032 mg/L
Asbestos
fibers/L
Barium
Cadmium 0.028 mg/L
Chromium (Hex.) 0.28 mg/L
Chromium (Tri.) 0.32 mg/L
Copper
Cyst 140,000
cysts/L
Lead 0.14 mg/L
25 pCi/L
Selenium 0.1 mg/L
TDS
Turbidity 11 NTU
Operating Specifications
Inlet Pressure
Inlet Temperature
Maximum TDS Level
Maximum Hardness @ 6.9pH
Maximum Chlorine
pH Range
Daily Production Rate
(3)
Efficiency Rating
(4)
Recovery Rating
Notes:
(1) Tested by NSF International per NSF/ANSI Standard 58 or NSF/ANSI Standard 42.
(2) NTU is Nephelometric Turbidity Units
(3) Efficiency rating means the percentage of the influent water to the system that is available to the user as reverse osmosis treated water under operating conditions that approximate
typical daily usage.
(4) Recovery rating means the percentage of influent water to the membrane portion of the system that is available to the user as reverse osmosis treated water when the system is
operated without a storage tank or when the storage tank is bypassed.

Performance Data

GE Appliances Reverse Osmosis System
Model(s): PNRQ15RBL, and PXRQ15RBL
NSF specified
Avg %
Challenge
Reduction
Concentration
2.0 mg/L ± 10%
At least 10,000 particles/
mL
0.050 mg/L ± 10%
10 7 to 10 8 fibers/L; fibers
10 mg/L
± 10%
0.03 mg/L ± 10%
0.3 mg/L ± 10% (added
as hexavalent)
0.3 mg/L ± 10% (added
as triavalent)
3.0 mg/L + 10%
Minimum 50,000 cysts/L
0.15 mg/L + 10%
25 pCi/L ± 10% 80.0%
0.10 mg/L ± 10% (added
as ½ selenite and ½
selenate)
750 mg/L + 40 mg/L
11 ± 1 NTU
2
40-120 psig (2.8-7.0 kg/cm )
40-100 F° (5-38° C)
2000 mg/L
10 grains per gal. (171 mg/L)
2.0 mg/L
4 – 10
8.46 GPD (32.0 L/day)
9.05%
19.84%
System tested and certified by NSF
International against NSF/ANSI to Standard 42,
Standard 58 and CSA B483.1 for the reduction
US
C
of substances as listed below.
Contaminant Reduction Determined by NSF testing.
Average Max Permissible
Product Water Product Water
Concentration Concentration
0.05 mg/L N/A
23 pts/mL N/A
0.010 mg/L
< 1 fiber/L NA
0.310 mg/L 2.00 mg/L
0.0003 mg/L 0.005 mg/L
0.008 mg/l 0.1 mg/L
0.01 mg/l 0.1 mg/L
0.027 mg/L 1.3 mg/L
3 cyst/L N/A
0.001 mg/L 0.010 mg/L
5 pCi/L 5 pCi/L
0.002 mg/L 0.05 mg/L
42 mg/L 187 mg/L
0.1 NTU 0.5 NTU
NSF Reduction NSF Test
Requirements Report
N/A J-00122054
N/A J-00122055
N/A
N/A J-00122054
N/A J-00122055
N/A
N/A
N/A J-00122055
N/A J-00122057
N/A
N/A
49-50322