Table of Contents
Advertisement
Operation
Center Rollers
1.
Disengage the power take off (PTO) and turn the
ignition key to "OFF". Move controllers to
neutral locked position and apply parking brake.
2.
After adjusting height-of-cut, remove bolt and
flange nut (Fig. 13).
3.
Select hole so gage wheel is positioned to the
nearest corresponding height-of-cut desired
(Fig. 13).
Note:
Do not adjust rollers to support the
deck.
4.
Reinstall the bolt, center rollers and flange nut
(Fig. 13).
3
1
Figure 13
1. Center Rollers and Spacer
2. Flange Nut
28
2
m–4124
3. Bolt
Positioning the Seat
The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable.
1.
To adjust, move the lever sideways to unlock
seat (Fig. 14).
2.
Slide the seat to the desired position and release
lever to lock in position.
1
Figure 14
1. Adjustment knob
m–3655
Advertisement
Table of Contents
