Figure 19
1. Outer roller
2. Spacer
3. Bushing
4. Select a hole so that the center rollers are positioned
to the nearest corresponding height-of-cut desired
(Figure 19).
Note: Do not adjust the rollers to support the
mower housing.
5. Install the center rollers, bushing, spacer, bolt, and
nut (Figure 19).
6. Torque the bolt to 40 to 45 ft-lb (54 to 61 N⋅m).
Positioning the Seat
The seat can move forward and backward. Position the
seat where you have the best control of the machine
and are most comfortable.
Important: To adjust, move the lever sideways to
unlock seat (Figure 20).
Slide the seat to the desired position and release lever
to lock in position.
4. Bolt
5. Nut
1. Adjustment lever
Unlatching the Seat
Push the seat latch rearward to unlatch the seat.
This will allow access to the machine under the seat
(Figure 21).
1. Seat latch
2. Fuel cap
Pushing the Machine by Hand
Important: Always push the machine by hand.
Never tow the machine because hydraulic damage
may occur.
Pushing the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to off. Move the levers to neutral locked
position and apply parking brake. Remove the key.
2. Rotate the by-pass valves counterclockwise 1 turn
to push. This allows hydraulic fluid to by-pass the
pump enabling the wheels to turn (Figure 22).
21
Figure 20
Figure 21
3. Seat