Pushing The Machine By Hand - Toro 74202 Operator's Manual

Pushing the Machine by Hand

IMPORTANT: Always push the machine by
hand. Never tow the machine because
hydraulic damage may occur.
To Push the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to "OFF" to stop the engine. Move
controllers to neutral locked position and apply
parking brake.
2. Rotate the by-pass valves counterclockwise 1
turn to push. This allows hydraulic fluid to
by-pass the pump enabling the wheels to turn
(Fig. 15).
IMPORTANT: Rotate by-pass valves a
maximum of 2 turns so the valves do not
come out of the body causing fluid to run out.
3. Disengage parking brake before pushing.
To Operate the Machine
1. Rotate the by-pass valves clockwise 1 turn to
operate machine (Fig. 15).
Note: The machine will not drive unless
by-pass valves are turned in.
Figure 15
1. By-pass valve
1
E
Operation
29