Table of Contents
Advertisement
3. After adjusting the height-of-cut, remove the flange nut,
bushing, spacer, and bolt (Fig. 18).
5
2
1
Figure 18
1. Outer roller
2. Spacer
3. Bushing
4. Select a hole so that the outer roller is positioned to the
nearest corresponding height-of-cut desired (Fig. 18).
5. Install the outer roller, bushing, spacer, bolt, and nut
(Fig. 18).
6. Torque the bolt to 40 to 45 ft-lb (54 to 61 N⋅m).
Adjusting the Center Rollers
1. Disengage the PTO, move the motion control levers to
the neutral locked position, and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. After adjusting the height-of-cut, remove the flange nut,
bushing, and bolt (Fig. 19).
4
3
m–7713a
4. Bolt
5. Nut
21
4
1
Figure 19
1. Center rollers
2. Bushing
4. Select a hole so that the center rollers are positioned to
the nearest corresponding height-of-cut desired
(Fig. 19).
Note: Do not adjust the rollers to support the mower
housing.
5. Install the center rollers, bushing, spacer, bolt, and nut
(Fig. 19).
6. Torque the bolt to 40 to 45 ft-lb (54 to 61 N⋅m).
Positioning the Seat
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are
most comfortable.
1. To adjust, move the lever sideways to unlock the seat
(Fig. 20).
1
Figure 20
1. Adjustment lever
2. Slide the seat to the desired position and release the
lever to lock the seat in position.
3
2
m–7712a
3. Bolt
4. Nut
m–3655
Advertisement
Table of Contents
