Table of Contents
Advertisement
Figure 20
1. Outer roller
2. Spacer
3. Bushing
4. Select a hole so that the center rollers are
positioned to the nearest corresponding
height-of-cut desired (Figure 20).
Note: Do not adjust the rollers to support
the mower housing.
5. Install the center rollers, bushing, spacer, bolt,
and nut (Figure 20).
6. Torque the bolt to 40 to 45 ft-lb (54 to 61
N⋅m).
Positioning the Seat
The seat can move forward and backward.
Position the seat where you have the best control
of the machine and are most comfortable.
Important: To adjust, move the lever
sideways to unlock seat (Figure 21).
Slide the seat to the desired position and release
lever to lock in position.
4. Bolt
5. Nut
Figure 21
1. Adjustment lever
Unlatching the Seat
Push the seat latch rearward to unlatch the seat.
This will allow access to the machine under the
seat (Figure 22).
Figure 22
1. Seat latch
2. Fuel cap
Pushing the Machine by
Hand
Important: Always push the machine
by hand. Never tow the machine because
hydraulic damage may occur.
Pushing the Machine
1. Disengage the power take off (PTO) and
turn the ignition key to off. Move the levers
23
3. Seat
Advertisement
Table of Contents
