Unfolding The Handle - Toro 38571 Operator's Manual

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1.
2.

1. Unfolding the Handle

Procedure
1. Loosen the handle knobs, pull out the "U"-shaped
handle locks until you can move the handle freely,
and rotate the handle to the operating position
(Figure 3).
1. "U"-shaped handle lock (2) 2. Handle knobs
2. Insert the end of the "U"-shaped handle lock into
the open hole in the handle and tighten the handle
knobs until they are snug (Figure 4).
Description
No parts required
Screws
Chute assembly
Discharge chute handle
Figure 3
Qty.
–
Unfold the handle.
3
1 Install the discharge chute.
1
Important: Ensure that you do not pinch or
kink the control cable (Figure 5).
1. Control cable
5
Use
Figure 4
Figure 5