Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
1
Unfolding the Handle
No Parts Required
Procedure
1. Loosen the handle knobs, pull out the "U"-shaped
handle locks until you can move the handle freely,
and rotate the handle to the operating position
(Figure 4).
1. "U"-shaped handle lock (2) 2. Handle knobs
2. Insert the end of the "U"-shaped handle lock into
the open hole in the handle and tighten the handle
knobs until they are snug (Figure 5).
Description
No parts required
Screws
Chute assembly
Figure 4
Qty.
–
Unfold the handle.
3
Install the discharge chute.
1
Important: Ensure that you do not pinch or
kink the control cable or the Quick Shoot™
cables (Figure 6).
1. Control cable
5
Use
Figure 5
Figure 6
2. Quick Shoot™ cables