AEG BE731410HM User Manual page 16

16 www.aeg.com
The display shows
default set core temperature. The
temperature is 60 °C for the first
operation, and the last set value for each
subsequent operation.
When you put the core
temperature sensor into the
socket, you cancel the
settings for the clock
functions.
4. Touch
temperature.
5. Touch
automatically after 5 seconds.
You can set the core
temperature only when
display but does not
flash before you set the
core temperature, touch
a new value.
6. Set the oven function and the oven
temperature.
The display shows the current core
temperature and the heat up symbol
While the appliance calculates the
approximate duration time, the display
shows the count up time. After the first
calculation the display shows the
approximate duration of the cooking
time.
The appliance continues to calculate the
duration during the cooking. The display
updates at intervals with the new
duration value.
flashing and the
or to set the core
or the settings save
flashes. If is in the
and or to set
When you cook with the
core temperature sensor,
you can change the
temperature shown in the
display. After you put the
core temperature sensor in
the socket and set an oven
function and temperature,
the display shows the
current core temperature.
Touch
see three other
temperatures:
• the set core
• the current oven
• the current core
When the meat is at the set core
temperature, an acoustic signal sounds
for two minutes and the value of the core
temperature and
deactivates.
7. Touch a sensor field to deactivate
the acoustic signal.
8. Remove the core temperature sensor
from the socket and remove the
meat from the appliance.
WARNING!
Be careful when you remove
the core temperature
sensor. It is hot. There is a
risk of burns.
9.2 Inserting the accessories
Wire shelf:
Push the shelf between the guide bars of
.
the shelf support and make sure that the
feet point down.
again and again to
temperature
temperature
temperature.
flash. The appliance