Changing Pre-Set Options; Option Adjustment Mode - Fisher & Paykel WA42T26GW1 Installation Instructions And User Manual

Changing pre-set options

US
24
CA

Option adjustment mode

After using your Ecosmart™ you may want to fine tune some of the options to suit your
wash needs.
You can change the following pre-set options:
The default rinse option.
■ ■
The amount of water used in the SPRAY RINSE.
■ ■
The number of beeps at the end of the cycle.
■ ■
The out of balance recovery routine.
■ ■
The fill level selected by auto water level.
■ ■
The controlled cold option.
■ ■
To make these changes it is necessary to enter the "Option Adjustment Mode".
To enter option adjustment mode
Plug the machine in, but do not press POWER.
1
Press START/PAUSE and hold down, then press POWER.
You will hear three quick beeps and the machine will show
2
an unusual pattern of lights. In this mode the lights are
used to indicate the different options available. The diagram
on page 25 shows how the lights relate to the options you
can change. Pages 26 – 27 explain the different options in
more detail.
Use the buttons on the panel to make your changes to the
3
pre-set options.
Press POWER to return to normal mode.
4
Your Ecosmart™ will automatically remember your changes.
5
To make further changes, repeat the above steps.
6
Fig.33 Entering Option Adjustment mode