Toro 07287 Operator's Manual page 33

Troubleshooting
Vehicle Status Light Flash Pattern
Problem
Always on
1 ash
2 ashes
3 ashes
Possible Cause
1. The system is functioning
properly.
1. The computer
programming
personality is out of
range.
1. The accelerator pedal
was pressed when the
On/Off key was turned.
1. The power block has a
short circuit (MOSFET
S/C).
2. A poor batter or power
cable connection.
33
Corrective Action
1. None
1. Turn the On/Off key to
the Off position, wait
a few seconds, and
turn the On/Off key to
the On position. If the
condition continues,
refer to your Authorized
Service Dealer.
1. Turn the On/Off key to
the Off position, release
the accelerator pedal,
and turn the On/Off key
to the On position.
1. Turn the On/Off key
to the Off position,
wait a few seconds,
and turn the On/Off
key to the On position.
Check all batteries and
high current controller
connections If the
condition continues,
refer to your Authorized
Service Dealer.
2. Turn the On/Off key
to the Off position,
wait a few seconds,
and turn the On/Off
key to the On position.
Check all batteries and
high current controller
connections If the
condition continues,
refer to your Authorized
Service Dealer.