Pre-Starting Checks; Starting The Engine; Driving The Sprayer - Toro 41163 Operator's Manual

Neutral Engine Speed Control Switch
When the range selector is in the Neutral position, you can
use the accelerator pedal to speed up the engine, then push
this switch forward to set the engine at that speed. This is
necessary to run attachments such as the hand sprayer
(Fig. 15).
Fuel Gauge
The fuel gauge (Fig. 16) shows the amount of fuel in the
tank.
Figure 16
1. Fuel gauge

Pre-Starting Checks

Check the following items each time you begin using the
sprayer for the day:
• Check the tire pressure.
Note: These tires are different than car tires; they
require less pressure to minimize turf compaction and
damage.
• Check all fluid levels and add the appropriate amount of
specified fluids, if any are found to be low.
• Check the brake pedal operation.
• Check to see that the lights are working.
• Turn the steering wheel to the left and right to check
steering response.
• Check for oil leaks, loose parts, and any other
noticeable malfunctions. Make sure the engine is off
and all moving parts have stopped before checking for
oil leaks, loose parts, and other malfunctions.
If any of the above items are not correct, notify your
mechanic or check with your supervisor before taking the
sprayer out for the day. Your supervisor may want you to
check other items on a daily basis, so ask what your
responsibilities are.

Starting the Engine

1. Sit in the operator's seat, insert the key into the ignition
switch, and rotate the key clockwise to the Run
position.
2. Press the brake and move the range selector to the
Neutral position.
3. Ensure that the pump switch is in the Off position.
4. If the engine is cold, pull the choke knob up.
Important
5. Turn the key to the Start position until the engine starts.
Important
more than 10 seconds. If the engine has not started after 10
seconds, wait 1 minute before trying again. Do not attempt
to push or tow the sprayer to start the engine.
6. Once the engine starts, push the choke knob down
slowly.
1

Driving the Sprayer

1. Press the brake pedal.
2. Push the parking brake lever forward to release it.
3. Move the range selector into the desired range.
4. Press the accelerator pedal to drive or press the brake to
stop.
Note: Stopping distance may vary depending on the
sprayer load and speed.
19
Do not use the choke if the engine is warm.
Do not hold the key in the Start position for