Table of Contents
Advertisement
To apply flash exposure compensation, press the up or down buttons on the flash to increase or decrease
flash exposure by 1/3 stop—up to 3 stops total. The LCD will display EV+ or EV- next to the exposure value to
indicate whether it is increased or decreased.
Using the Manual Flash Mode
You can also set the VS-570N's flash output level manually for greater creative control over your images.
Seven manual settings are available: 1/1, 1/2, 1/4, 1/8, 1/16, 1/32, and 1/64. The 1/1 setting is the full-power
flash, and each successive setting halves the light
output. To use the manual mode, turn the flash and
camera on and follow these steps:
1.
Press the Mode button repeatedly to cycle through
the flash modes until "M" and the flash output
level indicator show on the LCD. Press the up or
down buttons to set the desired flash output level.
The output level will cycle through in
both directions.
|
20
Using the Manual Flash Mode
M
Advertisement
Table of Contents
