Changing The Brake Fluid; Drive Belt Slack - Yamaha 2010 XVS1300AZ Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
G
Be careful that water does not en-
ter the brake fluid reservoir when
refilling. Water will significantly
lower the boiling point of the fluid
and may result in vapor lock.
G
Brake fluid may deteriorate paint-
ed surfaces or plastic parts. Al-
ways clean up
immediately.
G As the brake pads wear, it is nor-
mal for the brake fluid level to grad-
ually go down. However, if the
brake fluid level goes down sud-
denly, have a Yamaha dealer
check the cause.
7

Changing the brake fluid

Have a Yamaha dealer change the
brake fluid at the intervals specified in
the TIP after the periodic maintenance
and lubrication chart. In addition, have
the oil seals of the master cylinders and
calipers as well as the brake hoses re-
spilled fluid
placed at the intervals listed below or
whenever they are damaged or leak-
ing.
G Oil seals: Replace every two
years.
G
Brake hoses: Replace every four
years.
EAU22731

Drive belt slack

The drive belt slack should be checked
and adjusted at the intervals specified
in the periodic maintenance and lubri-
cation chart.
To check the drive belt slack
1. Place the vehicle on the sidestand.
2. Note the current position of the
TIP
The marks near the drive belt check
hole are 5.0 mm (0.2 in) apart.
2
1. Drive belt
2. Marks
3. Drive belt slack
7-20
drive belt using the marks near the
drive belt check hole.
3
1
EAU23040
EAU38410