Command
Setting
Code
Source
SOURCE.SELECT
Select
Splash
SPLASH.SCREEN
Screen
Subnet Mask
IPV4.NETMASK
System State
SYSTEM.STATE
Test Email
NETWORK.SMTP.
TEST
Modifiers
101
=?+-
Zone
Source
0 = ZONE.1
0 = OPS
1 = ZONE.2
1 = HDMI.1
2 = ZONE.3
2 = HDMI.2
3 = ZONE.4
3 = HDMI.3
254 = ALL
4 = HDMI.4
255 =
5 = DP
CURRENT
[None =
CURRENT]
1305
=?+-
0 = DISABLE
1 = ENABLE
1205
=?
0 = STATIC
String
[None =
Current (for
reads only]
[None =
STATIC (for
writes only]
2310
?
0 = STANDBY
1 =
POWERING.ON
2 = ON
3 = POWERING.
DOWN
4 =
BACKLIGHT.OFF
5 = FAULT
1229
!
Event
0 = POWER.
STATE.
CHANGED
1 = ERROR.
OCCURRED
2 = SOURCE.
DETECTED
3 =
SOURCE.LOST
4 = SOURCE.
SELECTED
Planar QE Series RS232 User Manual
Operands
No
[For Zone 1]
SOURCE.SELECT(ZONE.1)=HDMI.1
SOURCE.SELECT(ZONE.1):HDMI.1
[For the current zone]
SOURCE.SELECT=HDMI.2
SOURCE.SELECT:HDMI.2
No
SPLASH.SCREEN=ENABLE
SPLASH.SCREEN:ENABLE
Yes
[Read the current subnet mask value]
IPV4.NETMASK?
IPV4.NETMASK:"255.255.254.0"
[Write the subnet mask for static IP]
IPV4.NETMASK(STATIC)="255.255.255.0"
IPV4.NETMASK(STATIC):"255.255.255.0"
No
SYSTEM.STATE?
SYSTEM.STATE:STANDBY
Yes
NETWORK.SMTP.TEST(SOURCE.LOST)
NETWORK.SMTP.TEST(SOURCE.LOST)@ACK
Example
See Main -> Inputs and
Views -> Zone 1/2/3/4
See Main -> Advanced
Settings -> Menus and
Messages -> Allow Splash
Screen
See Main -> Advanced
Settings -> Network -> Subnet
Mask
Indicates the current state of
the system:
- STANDBY: The system is in its
lowest power mode. Not all
functions are available.
- POWERING.ON: The system is
transitioning from the
STANDBY state to the ON
state.
- ON: The system is on with the
backlight on.
- POWERING.DOWN: The
system is transitioning from
the ON state to the STANDBY
state.
- FAULT: A system failure has
occurred. Use the Error Log
command to get more
information.
See Remote Monitoring
Software -> Notifications ->
Test Email
RS232 Codes
Notes
29