Table of Contents
Advertisement
Cleaning and maintenance
en
Open and remove the service flap.
3.
Take the drain hose out of the
4.
retainer.
Remove the sealing cap, allow the
detergent solution to flow out into a
suitable container.
Replace the sealing cap and place
the drainage hose in the retainer.
Carefully unscrew the pump cover,
5.
residual water may leak out.
Clean the interior, pump cover
thread and pump housing. The
impeller in the detergent solution
pump must be able to rotate.
Refit the pump cover and screw it on
tightly. The handle must be in a
vertical position.
Place the service flap back on, lock
6.
it into place, and close it.
30
To prevent unused detergent
Note:
from flowing straight into the drain
during the next wash: Pour 1 litre of
water into compartment II and start
the Spin/Drain programme (if only drain
cycle is required, set (Spin
speed) 0 on - - - ).
The drain hose at the siphon
is blocked
Switch off the appliance. Disconnect
1.
the mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose; residual
water may leak out.
Clean the drain hose and siphon
3.
connecting piece.
Reattach the drain hose and secure
4.
the connection using the hose
clamp.
Filter in the water supply is
blocked
For this, first reduce the water pressure
in the supply hose:
Turn off the water tap.
1.
Select any programme (except
2.
Rinse // Spin/Drain ).
Press Start/Reload ! . Allow the
3.
programme to run for approximately
40 seconds.
Set the programme selector to off
4.
position. Disconnect the mains plug.
Clean the filter on the water tap:
5.
Remove the hose from the water tap.
Clean the filter with a small brush.
Advertisement
Table of Contents
