Adjusting The Caster Position - Toro 30528 Operator's Manual

5. Loosen, but do not remove, the 2 axle pivot bolts
(Fig. 26).
6. Remove the 2 axle adjustment bolts (Fig. 26).
1
E
D
C
B
A
Figure 26
1. Axle pivot bolt
7. Raise or lower the mounting bracket, so that you can
install the 2 axle adjustment bolts in the desired hole
location (Fig. 26). A tapered punch can be used to help
align the holes.
8. Tighten all 4 bolts.
9. Install drive wheels and lower the mower.

Adjusting the Caster Position

1. Using the Height-of-Cut Chart (on page 26), adjust the
caster spacers to match with the axle hole selected
(Fig. 27).
2
Figure 27
1. Clevis pin
2. Spacer, 3/16 inch (5 mm)
2. Remove the clevis pin, slide the caster from the support,
and change the spacers (Fig. 27).
3. Install the caster in the support and insert the clevis pin
(Fig. 27).
1
3
m–3791
3. Spacer, 1/2 inch (13 mm)
25