Table of Contents
Advertisement
Rear Knuckles
Lubricate two grease fittings on each axle with 2 or 3 shots of
grease every 50 hours or after each use if consistently running
unit in water deeper than axle. See Fig. 6-6.
Figure 6-6
Draining CVT Cover
Drain CVT cover every 50 hours or after driving vehicle through
more than 12" of water.
1.
Lube
2.
3.
Cleaning
The body panels are scratch and impact resistant automotive
quality ABS plastic. The use of standard car wash soap and
non-abrasive car wax is acceptable for cleaning the body panels.
Avoid any abrasive cleaner or rubbing compounds for these will
damage the body panels. Dry thoroughly to avoid water spots.
Remove CVT cover drain plug. See Fig. 6-7.
Figure 6-7
Allow water to completely drain out.
Reinstall drain plug, and tighten securely.
WARNING:
DO NOT use a pressure washer.
Damage may occur if direct hose spray comes in
contact with intake openings, or any other electrical
components, i.e. at instrument cluster or under
dash.
s
6 — M
ectiOn
aintenance
& a
17
djustMents
Advertisement
Table of Contents
