Charging Instructions - oset 16.0 ECO Owner's Manual

CHARGING INSTRUCTIONS:

NOTE:
AGM Batteries: The newer type of sealed non-spillable maintenance free valve
regulated battery uses "Absorbed Glass Mats", or AGM separators between the
plates. This is a very fine fiber Boron-Silicate glass mat. These are also called
"starved electrolyte." The AGM Battery will not leak acid if broken.
• Check that the charger is switched to the correct voltage for your country.
• Ensure that the Power Switch on your OSET is switched OFF before
connecting the charger to the charge port.
• Carefully align the connector pins and connect the charger to the bike by
plugging the connector into the charger receptacle. Twist the lock ring to secure
the charger lead to the bike.
• Plug the charger into the wall outlet.
• Switch the charger on.
• LED Indications:
- The LED will illuminate RED when the charger is plugged into a wall outlet.
- The Indicator LED will illuminate YELLOW while the charger is charging the
battery.
- The Indicator LED will change to GREEN when the battery is fully charged.
• When charging is complete (the Indicator LED is GREEN), switch the charger
off, then carefully unplug the charger from the wall socket, then from the bike by
twisting the lock ring and pulling the connector out of the charger receptacle.
• Your OSET electric bike is now ready for use.
Charge Port OSET Charger
WARNING!
Use only the supplied battery charger. If you use any other battery charger,
you will void the warranty, you may damage the batteries and you could
cause a fire that would result in property damage and possible injury or
death.
23