Kobalt K20LD-26A Manual page 54

OPERATING INSTRUCTIONS
 5HPRYLQJ %LWV
a. Lock the trigger switch by placing the direction-of
rotation selector (D) in the OFF (center) position.
b. Pull the sleeve (A) towards the front of the tool and
hold it in place.
c. Remove the bit from the hexagonal hole in the bit
retainer.
d. Release the sleeve.
Tightening and Loosening Screws and Nuts
a. Install the correct bit.
E $SSO\ MXVW HQRXJK SUHVVXUH WR NHHS WKH ELW HQJDJHG
on the screw or nut.
c. Apply minimal pressure to the trigger switch (A)
initially. Increase the speed only when you can
maintain full control.
WARNING: Do not overtighten, as the force of the vimpact driver can break the fastener. Keep
the Impact driver at a right angle to the fastener to avoid damaging the fastener head.
11
13
A
D