Kobalt K20LD-26A Manual page 52

OPERATING INSTRUCTIONS
 'LUHFWLRQRI5RWDWLRQ 6HOHFWRU
(Forward/Center Lock/Reverse)
The direction of bit rotation is reversible and is
controlled by a selector located above the trigger
switch (B). With the impact driver held in the normal
operating position, pointing away from you:
a. Position the direction-of-rotation selector (D) to the
left of the tool for forward rotation.
b. Position the direction-of-rotation selector to the right
of the tool for reverse rotation.
c. Setting the switch in the OFF (center lock) position
helps reduce the possibility of accidental start-up
when not in use.
NOTICE: To prevent gear damage, always allow the
impact driver to come to a complete stop before changing
the direction of rotation.
NOTICE: The impact driver will not run unless the
direction-of-rotation selector is engaged fully to the left
or right.
Electric Brake
To stop the impact driver, release the trigger switch (B) and allow the tool to come to a complete
stop.
The electric brake quickly stops the rotation. This feature engages automatically when you release
the trigger switch.
NOTICE: This impact driver is equipped with an electric brake. When the brake is functioning
properly, sparks may be visible through the vent slots in the housing. This is normal and is the action
of the brake.
8
D
11
D