Operating Instructions - Kobalt K20LD-26A Manual

OPERATING INSTRUCTIONS

 $WWDFKLQJ WKH %DWWHU\ 3DFN VROG VHSDUDWHO\
NOTICE: This 20 V Impact Driver is compatible with
Kobalt Compact Lithium-ion Battery (0352546), Kobalt
Extended Run Lithium-ion Battery (0352548), Kobalt 18V
NiCd Battery (0005667), Kobalt Compact Lithium-Ion
Battery (0437530), and Kobalt Extended Run Lithium-Ion
Battery (0437531).
a. Place the direction-of-rotation selector (D) in the
center (locked) position.
b. Align the raised portion on the battery pack with the
grooves on the bottom of the impact driver, then slide
the battery pack onto the impact driver as shown.
c. Ensure that the battery-release button on the
battery pack snaps into place and the battery pack
is secured to the impact driver before beginning
operation.
NOTICE: When placing the battery pack on the tool, be sure that the raised rib on the battery pack
aligns with the groove on the impact driver and the latches snap into place properly. Improper
assembly of the battery pack can cause damage to internal components.
 'HWDFKLQJ WKH %DWWHU\ 3DFN VROG VHSDUDWHO\
a. Place the direction-of-rotation selector (D) in the
center (locked) position.
b. Press the battery-release button to release the
battery pack.
c. Pull forward on the battery pack to remove it from the
impact driver.
WARNING: Battery tools are always in operating
condition. Therefore, the direction-of-rotation selector
should always be locked (center) when the tool is not in
use or when carrying the tool at your side.
1
Release
Button
2
Release
Button
8
Battery
Pack
Battery
Pack
D
D