Kobalt K20LD-26A Manual page 12

OPERATING INSTRUCTIONS
7. Drill Mode
Select the drill mode for drilling and other heavy-
duty applications. To select the drill mode, rotate the
WRUTXH DGMXVWPHQW ULQJ C ) until the drill icon aligns
with the torque indicator and clicks into position.
8. LED Work Light
The LED work light (D), located above the trigger
switch ( A ), will illuminate when the trigger switch
is depressed. This provides additional light on the
surface of the workpiece for operation in lower-light
areas. The LED work light will turn off when the
trigger switch is released.
9. Installing The Belt Clip
a. Align the rib of the belt clip (J) with the hole on the
base of the drill.
b. Insert the screw (L) and tighten the screw securely
with a Phillips screwdriver (not included).
Removing the Belt Clip (Fig. 9)
a. Use a screwdriver to loosen the screw (L) that
attaches the belt clip (J) to the drill.
b. Remove the screw and the belt clip.
7
8
C
A
9
12
C
L J
J