Hardware Installation - Ubiquiti am-v5g-ti Quick Start Manual

Hardware Installation

1. Set the desired beamwidth by adjusting the Beamwidth
Deflectors. Use a 3 mm hex key driver to loosen the four hex
head screws, but do not remove the screws.
2. Carefully move the Beamwidth Deflectors to the desired
angle, as indicated by the screw slots.
Important:
angle.
3. Tighten the four hex head screws.
Both deflectors must be set to the same
120° Beamwidth
90° Beamwidth
60° Beamwidth