Bulbs - Cover - Volvo V60 Cross Country Owner's Manual

10 Maintenance and servicing
||
CAUTION
When disconnecting the connector, pull on
the connector itself and not on the wiring.
10
Unplug the wiring connector by holding
down the clip with your thumb.
Pull the connector out with the other
hand.
5. Lift out the headlight housing and place it
on a soft surface to avoid scratching the
lens.
6. Replace the defective bulb(s).
Reinserting the headlight housing
1. Plug in the connector until it clicks into
place.
340
2. Reinstall the headlight housing and lock-
ing pins. The short locking pin should be
closest to the grille. Check that they are
correctly inserted.
The headlight housing must be properly
in place and the wiring connector cor-
rectly reconnected before the lighting is
switched on or the remote key is inserted
into the ignition slot.
3. Check that the lights function properly.
Related information
•
Bulbs – introduction (p. 338)
•
Bulbs – cover (p. 340)
•
Bulbs – specifications (p. 345)
Bulbs – cover
The larger cover has to be removed in order
to change the high/low beam headlight bulbs.
Removing the cover to access the bulbs
NOTE
Before starting to replace a bulb, see
Bulbs – introduction (p. 338).
1. Loosen the cover's four retaining screws
(3-4 turns) with a Torx T20 tool (1). The
screws should not be removed com-
pletely.
2. Push the cover to the side.
3. Remove the cover.
Reinstall the cover in the reverse order.