Homelink ® Wireless Control System* - Programming - Volvo V60 Cross Country Owner's Manual

WARNING
•
If you use HomeLink to open a garage
door or gate, be sure no one is near
the gate or door while it is in motion.
•
When programming a garage door
opener, it is advised to park outside of
the garage.
•
Do not use HomeLink with any garage
door opener that lacks safety stop and
reverse features as required by U.S.
federal safety standards (this includes
any garage door opener model manu-
factured before April 1, 1982). A
garage door that cannot detect an
object - signaling the door to stop and
reverse - does not meet current U.S.
federal safety standards. For more
information, contact HomeLink at:
www.homelink.com.
Retain the original transmitter of the RF
device you are programming for use in other
vehicles as well as for future HomeLink pro-
gramming. It is also suggested that upon the
sale of the vehicle, the programmed Home-
Link buttons be erased for security purposes.
Refer to "Resetting HomeLink Buttons" in
®
HomeLink Wireless Control System* – pro-
gramming (p. 107).
Using HomeLink
To operate, simply press and hold the pro-
grammed HomeLink button until the trained
device begins to operate (this may take sev-
eral seconds). Activation will now occur for
the trained device (i.e., garage door opener,
gate operator, security system, entry door
lock, home/office lighting, etc.). For conven-
ience, the hand-held transmitter of the device
may also be used at any time. In the event
that there are still programming difficulties or
questions, contact HomeLink at:
www.homelink.com or by phoning the hotline
at 1–800–355–3515.
NOTE
If the ignition is switched off, HomeLink
will function for 30 minutes after the driv-
er's door has been opened.
03 Instruments and controls
®
HomeLink Wireless Control System*
– programming
The HomeLink 23 Wireless Control System
provides a convenient way to replace up to
three hand-held radio-frequency (RF) trans-
mitters used to activate devices such as gate
operators, garage door openers, entry door
locks, security systems, even home lighting.
Additional information can be found on the
Internet at www.homelink.com or by phoning
the hotline at 1–800–355–3515.
NOTE
Some vehicles may require the ignition to
be switched on or be in the "accessories"
position for programming and/or operation
of HomeLink. It is also recommended that
a new battery be placed in the hand-held
transmitter of the device being pro-
grammed to HomeLink for quicker training
and accurate transmission of the radio-fre-
quency signal. The HomeLink buttons
must be reset first. When this has been
completed, Homelink is in learning mode
so that you can perform programming.
1. Position the end of your hand-held trans-
mitter 1–3 inches (5–14 cm) away from
the HomeLink button you wish to pro-
gram while keeping the indicator light in
view.
*
Option/accessory, for more information, see Introduction.
03
}}
107